DRYER
INSTALLATION (Pedestal) continued
4. Holding the adhesive part of the
bracket away from the dryer,
insert the screws and get them
started.
Press the bracket onto the dryer
and tighten the screws.
5. Press the brackets onto the
sides of the dryer and rub the
brackets from side to side to
ensure the total adhesive area is
attached completely.
6. Tighten all the screws securely.
7. Lower each leg of the dryer one-
fourth turn with the adjusting
wrench to put a little pressure
between the dryer and pedestal
to prevent any motion and
rattling.
8. Push the dryer into place.
9. Check the level and adjust the
front legs of the pedestal as
necessary. Then lock down the
adjusters.
The pedestal kit includes the mounting
plates (with adhesive covered by
paper) and the screws to attach the
plates. Remember, some pedestal kits
come with two sets of brackets. The flat
tops are for washers; the curved tops
(shown) are for dryers. Use the correct
brackets for your application.
DLE8377xM/DLG8388xM
DLE7177WM/DLE7188WM Page 14 of 60 TRAINING MANUAL
To Next Page
Loading...
Need help?
General
