- 92-
13. ICEMAKER OPERATING METHOD AND TROUBLE SHOOTING
13-1 Icemaker’s Basic Operating Method
nO rewoP nO rewoP
Start Position
• Adjusts Ice Tray to Start Position with power on.• Adjusts Ice Tray to Start Position with power on.
Icemaking
Mode
Full Ice
Check
Harvest
Mode
Full Ice?
Fill
Test Mode
• If water becomes ices in the ice tray, Ice-detecting
sensor check if the ice bin is full.
• Twist the ice tray to drop ice into the ICE BIN.
• Supply water to the ice tray by operating the solenoid
valve.
• To force water to supply to the ice tray, or check
icemaker’s condition press and hold the FILL Key for
about 3seconds.
In the test mode, The icemaker will run through 3
stages step by step
: Harvest
→
Fill water
→
Ice making
To reset the icemaker’s operation, set the power switch OFF position and back it to ON position.
Icemaker Unit
Power
Switch
Ice Tray
Ice-detecting sensor
• Waits until water becomes ice.
※For cold air circulation, Ice tray will be
on a slightly tilt one hour after
ice-making mode begins. Atilt ice tray
means icemaker’s normal operation.
Ice Tray on a slightly tilt
To Next Page
Loading...
Need help?
General
