Due to our policy of continuous product innovation, some specifications may change without notification.  
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
PRE-COMMISSIONING CHECKLIST
Page 1
Job Name / Location ________________________________________________________________________ Tag # _________________
Date:  ____________________________________________________________________________________
Address:  _________________________________________________________________________________
 
 _________________________________________________________________________________
Refrigerant Circuit Preparation 
'HVFULSWLRQ Check
8VLQJDFRS\RIWKH/$760XOWL9SLSHGHVLJQGLDJUDPYHULI\WKHVXPRIWKHLQGRRUXQLWQRPLQDOFDSDFLW\FRQQHFWHGWRWKHSLSLQJ
V\VWHPLVEHWZHHQDQGRIWKHRXWGRRUXQLW¶VV¶QRPLQDOFDSDFLW\,IWKLVUXOHLVYLRODWHGWKHV\VWHPZLOOQRWVWDUW
Check all indoor units for power at the unit disconnect and power is present at the indoor unit PCB board. (LED is lit.)  DO 
NOT TURN ON THE UNIT using the ON/OFF button.
Successful auto address routine is complete. All device addresses have been recorded on the Indoor Unit Device Configuration 
Worksheet.
Ensure all field-installed full-port ball valves are open.
The piping system must hold a constant 550 psig pressure for a minimum of 24 hours with all isolation valves open.
$WULSOHV\VWHPHYDFXDWLRQKDVEHHQSHUIRUPHG0LFURQJDXJHUHDGLQJKHOGDWDPLQLPXPRIIRUKRXUZLWKDOOLVRODWLRQYDOYHV
open and without the vacuum pump connected.
Power was energized to the outdoor unit(s) at ______________(time) on __________day to warm the compressor crankcase. 
0XVWEHDWOHDVWVL[>@KRXUVEHIRUHFRPPLVVLRQLQJ
The communications cable to the indoor units has been disconnected from the IDU (B) and IDU (A) terminals at the outdoor 
unit(s).
None of the outdoor unit(s) service valves have been opened during the installation and preparation of the system for  
commissioning. (If the valves were opened, the factory refrigerant charge has been released.)
3UHVVXUH0HDVXUHPHQW'DWD
Initial Pressure  ________________________________
Start Date  ____________________________________
Start Time  ____________________________________
Initial Ambient Temperature  ______________________
End Pressure  _________________________________
End Date   ____________________________________
End Time  ____________________________________
End Ambient Temperature  _______________________
Evacuation
,QLWLDO0LFURQ/HYHO _____________________________
Start Date  ____________________________________
Start Time  ____________________________________
(QG0LFURQ/HYHO ______________________________
End Date   ____________________________________
End Time  ____________________________________
Rise  ________________________________________