LG Multi V Water IV - Wiring Safety Precautions; Electrical Work Standards

6
MULTI V Water IV System Installation Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
The information in this manual is intended for use by an
industry-qualied, experienced, certied electrician who
is familiar with the U.S. National Electric Code (NEC) and is
equipped with the proper tools and test instruments.
Failure to carefully read and follow all instructions in this manual can
result in equipment malfunction, property damage, personal injury or
death.
All electric work must be performed by a licensed electrician
and conform to local building codes or, in the absence of
local codes, with the National Electrical Code, and the
instructions given in this manual. If there is a conict be-
tween the instructions in this manual and any local or na-
tional codes, follow the requirements of the local or national
codes.
If the power source capacity is inadequate or the electric work is not
performed properly, it may result in re, electric shock, physical injury
or death.
High voltage electricity is required to operate this system.
Adhere to the NEC code and these instructions when wiring.
Improper connections and inadequate grounding can cause acciden-
tal injury or death.
Always ground the unit following local, state, and NEC codes.
There is risk of re, electric shock, and physical injury or death.
Properly size all circuit breakers or fuses.
There is risk of re, electric shock, explosion, physical injury or
death.
Refer to local, state, and federal codes, and use power wires
of sufcient current capacity and rating.
Wires that are too small may generate heat and cause a re.
Secure all eld wiring connections with appropriate wire
strain relief.
Improperly securing wires will create undue stress on equipment
power lugs. Inadequate connections may generate heat, cause a re
and physical injury or death.
Properly tighten all power lugs.
Loose wiring may cause a re by overheating at connection points,
resulting in equipment or property damage, physical injury, or death.
Do not change the settings of the protection devices.
If the pressure switch, thermal switch, or other protection devices are
bypassed or forced to work improperly, or parts other than those
specied by LG are used, there is risk of re, electric shock, explo-
sion, and physical injury or death.
Turn the power off at the nearest disconnect before servicing
the equipment.
Electrical shock can cause physical injury or death.
Do not supply power to the unit until all installation and
precommissioning tasks are complete and the LG authorized
commissioning agent indicates it is safe to do so.
SAFETY PRECAUTIONS
WIRING