LG PD36 - Sleep Timer Setting; SNOOZE Function

Operating 13
Operating
2
y
If you set ALARM1 and ALARM2 at the same
time, the ALARM1 function only works.
y
During the playback, if the time you set is
up, the function is switched to the function
you set for ALARM.
y
If the function you set for alarm does not
work, tuner function works automatically.
y
If the alarm stops, the function you set
works normally.
y
If you don’t set clock, the alarm function
doesn’t work.
y
In the TUNER, BUZZER, USB, IPOD mode, the
unit turns o at the preset time.
y
If you don’t connect the AC power cord to
the wall outlet, the alarm function doesn’t
work.
y
If you make a mistake while setting the
alarm, press and hold ALARM to reset the
alarm.
y
If you set the clock time, you can check the
time by pressing ALARM.
y
If you set the clock time and alarm, you
cancheckthealarmicon“
“andset
informaiton by pressing ALARM even
when the unit is turned o . Then this
function will work.
y
Since the alarm goes o, if you don’t press
any button for 10 minute, the alarm will stop
ringing automatically. (In only the BUZZER
mode)
y
When the alarm rings, you can turn o the
alarm by pressing all the buttons.(In only
the BUZZER mode.)
,
Note
Sleep Timer Setting
Press SLEEP repeatedly to select delay time
between10and180minutes.Afterthedelaytime,
unit will turn o. (You can see in the following
order,180->150->120->90->80->70->60->50
->40->30->20->10)
To cancel the sleep function, press SLEEP
repeatedlyuntil“OFF“appears.
SNOOZE function
This function wakes you up every 5 minutes if
you press SNOOZE. If the time you set is up, the
unit turns on automatically and the alarm rings. If
you press SNOOZE, the alarm stops ringing and
then the unit power o. The alarm rings again in 5
minutes.
y
Ifyousetthe“OFFtime”betweenSNOOZE
time, SNOOZE time will be priority.
y
If you press ALARM, SNOOZE function stop
working.
,
Note
PD36D-FP-AAUSLL-ENG.indd 13 11. 08. 26 �� 5:45