2-51
DIGITAL DISPLAY & MEDIA TRAINING MASTER
11. WIRELESS NETWORK SETUP
11-1. Basic Guidance for wireless network troubles.
Expectable Causes
1. BD-HTS maybe do not receive the radio frequency signal interrupted
by different obstacle. The obstacle can be walls, objects, and the
other wireless device. Or the distance between AP and BD-HTS can
be the interrupting.
2. Just after change the AP configuration, the changed configuration
(SSID, channel..) does not be applied in AP. It can be also cause of
wireless network malfunctions.
3. The wireless part in BD-HTS is located on front panel of the product.
If, therefore, BD-HTS is placed in narrow space, something like a TV cabinet it maybe not receive the radio
frequency signal normally.
4. The wrong configuration of AP.
Possible Solutions
1. It is good that BD-HTS is placed around AP as close as possible.
If the signal strength bar of AP like picture, move the AP close to BD-HTS
around.
2. Clear away the obstacles around BD-HTS.
3. If AP’s location is far from BD-HTS, make move the AP’s height of location. For instance, above shelf.
4. Check that AP’s configurations are set normally. (Please refer to the next sheet for various troubles)
To Next Page
Loading...
Need help?
General
