2-53
DIGITAL DISPLAY & MEDIA TRAINING MASTER
11-3. When access point connection failed.
Expectable Causes
1. A wrong security key.
2. Interference between BD-HTS and router.
3. Some obstacles like walls, long distance or another wireless device.
Possible Solutions
1. Follow the basic guidance of previous page.
2. If not effect, try the below process
11-4. When wireless dynamic IP is not set.
Expectable Causes
1. Interference between BD-HTS and router.
2. Wrong configuration of IP address of AP.
Possible Solutions
1. AP should be used as DHCP server.
Check whether DHCP server of AP is activated or not.
Power off AP and on, then restart AP.
Retry to setup wireless network connection.
Move BD-HTS to AP around.
Change from current security mode to No-security
mode.
Reset AP to be factory initial status.
If not working
If not working
If not working
If not working
Power off AP and on, then restart AP.
Move BD-HTS to AP around.Reset AP to be factory initial status.
Retry to setup wireless network connection.
If not working
If not working
If not working
To Next Page
Loading...
Need help?
General
