LG SP820 - Wired Network Configuration; Wired Network Setup Guide

Connecting12
Connecting
2
Wired Network Setup
If there is a DHCP server on the local area
network (LAN) via wired connection, this unit will
automatically be allocated an IP address. After
making the physical connection.
Home menu
/
[Settings]
/
[NETWORK]
/
[Network Connection]
Preparation
Before setting the wired network, you need to
connect the broadband internet to your home
network.
1. Select [Network Connection] option in the
[Settings] menu then press Wheel (
).
2. Read the preparations for the network settings
and then, select [Start Connection] to start the
connection.
3. Normally, when there is a DHCP server on
the local area network via wired connection,
Network will automatically be connected to the
unit.
Advanced Setting
If you want to set other network settings manually,
Select [Other Network List] on the [Network
Connection] menu and press Wheel (
).
1. Select the [Set Expert] to set the other network
setting.
2. Select [Wired] and press Wheel (
).
3. Select [Manual Input] to input IP adress in the IP
mode.
Normally, select [Auto Input] to allocate an IP
address automatically.
�
If there is no DHCP server on the network
and you want to set the IP address manually,
select [Manual Input] then set [IP Address],
[Subnet Mask], [Gateway] and [DNS Server].
�
When you input a digit in the blank, key pad
will be appeared on the screen.
,
Note
4. Select [OK] and press Wheel ( ) to apply
network settings.