Installation
Installation Manual 11
ENGLISH
3. When installing the unit in a place that is constantly exposed to a strong wind like a coast or on
a high story of a building, secure a normal fan operation by using a duct or a wind shield.
• Install the unit so that its discharge port faces to the wall of the building.
Keep a distance 300mm or more between the unit and the wall surface.
• Supposing the wind direction during the operation season of the air conditioner, install the
unit so that the discharge port is set at right angle to the wind direction.
General considerations
• If a sunroof is built over the unit to prevent
direct sunlight or rain exposure, make sure
that heat radiation from the heat exchanger is
not restricted.
• Ensure that the spaces indicated by arrows
around front, back and side of the unit.
• Do not place animals and plants in the path of
the warm air.
• Take the weight of the unit into account and
select a place where noise and vibration are
minimum.
• Select a place so that the warm air and noise
from the unit do not disturb neighbors.
• The surface of the ground or the structure
must be strong enough to bear the weight of
the unit.
Installation Conditions
To Next Page
Loading...
Need help?
General
