LG Therma V AHBW A0 Series Installation Manual

System Set-Up
46 Air-to-Water Heat Pump
Installer Setting
How to enter installer setting mode
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it could cause problems to the unit, user injury or
property damage. This must be set by an certificated installer, and any installation or change that
is carried out by a non-certificated person should be responsible for the results. In this case, free
service cannot be provided.
?)<-:
?)<-:
<-58
<-58
78-:
78-:
0-)<16/
0-)<16/
57,-
57,-
1
Function Code Value
Press Function Setting button for 3 seconds
to enter the installer setting mode.
(When you enter the installer setting mode
initially, function code is displayed on the bottom
of the LCD screen.)
Repeat pressing button, and the function code
will be changed from 01 to 2B.
Please refer the code table on the next page.
CAUTION

LG Therma V AHBW A0 Series Specifications

General

Brand	LG
Model	Therma V AHBW A0 Series
Category	Air Conditioner
Language	English