LI-7550 Analyzer Control Unit
LI-7200
7200-101 Flow Module
Power Supply
Anemometer
Data
Cable
Air IN
Filter
1/2” ID Tygon Tubing
ACCESSORY
Power Cable
Air OUT
VOLTAGE
CURRENT
VIN+
VIN-
Mounting the 7200-101 Flow Module
Two mounting plates (part number 9879-045) are included that can be used to
mount the 7200-101 using hose clamps to secure the box to a tripod or other post.
There are holes in the four corners of the box, as well, that can be used to attach
the box directly to a flat surface, if desired.
The mounting plates and hose clamps are designed to accommodate a square or cir-
cular mounting post of up to 2.75" in width (diameter). Hardware is included to
attach the mounting plates to the 7200-101 using 4 hex head bolts (part number
150-12943). The hose clamp mounting brackets are attached to the mounting
plates, and then the hose clamps can be inserted through the holes in the hose
clamp mounting brackets, and tightened around the post, as shown in Figure 1-4 on
the next page. The hose clamp mounting brackets can be inserted through any of
the holes in the mounting plates to accommodate a variety of mounting options, as
shown in Figure 1-4 on the next page.
Section 1. Overview of the 7200-101 Flow Module
1-5Mounting the 7200-101 Flow Module
To Next Page
Loading...
