Netlink Installation and Operation Manual
18 19
Installation and Operation
After selecting the Authorization level, enter the new user name in the User Name column and enter the password into the Password
column. Passwords must meet the complexity level setting requirements. Re-enter the password into the Verify Password column.
After clicking Submit, the new user will be active and another blank row will appear for entering the next user name.
2.2.12 Select Certificate
The Netlink allows a user-supplied certificate to be used. Click the "Select Certificate" button (Figure 2.9) to enter the Import Certificate
screen (Figure 2.8). Contact your IT department for more information.
.
Figure 2.8 - Import Certificate Screen
Click the Choose File button to select the certificate to be used, then click Download, then Confirm to download the certificate.
Click the Submit and Test button to use and test the certificate.
2.2.13 SSL Protocol and CipherSuite Settings
This section allows the user to select which SSL protocol to use. The default setting is Normal. See Figure 2.9
2.2.14 Certificate Log
Click Show Certificate Log to view the certificate activity log. Click Hide Certificate Log to hide the window. See Figure 2.9
2.2.15 Import and Export Configuration File
The Netlink allows the user to export the settings that are configured in the Netlink to a file. This file can be used as a backup or to
transfer these settings to other Netlink devices that require similar settings. The settings exported include:
– From Configure Page: Time Settings (including NTP Server), MSM Settings, SNMP Settings, VPN Settings, Netlink Module
Settings, User Settings
– From Reporting Page: Alert Enable On, Netlink Report, FPO1/2 Report, FPV1/2 Report
– Power Supply Settings (FPO/FPV) - for all connected power supplies
– M8 Programming - for all connected M8 boards (NL4/NLX only)
To export the settings, click the Export Configuration File button (See Figures 2.9 and 2.10). The exported file saves to the default
download location of the browser.
To import a configuration file, click the Import Configuration File button to open the Import Settings screen.
Click the Choose File button and select the configuration file to be imported. Click Download, then Confirm to import the settings.
2.2.16 IEEE802.1x Settings and Log
This section allows the user to set up IEEE802.1x authentication, if required. Click Submit after completing this section.
The "Show IEEE802.1x Log" button will show or hide the log on screen.
To Next Page
Loading...
Need help?
General
