Lighthouse REMOTE-2 PN Series - Start;Stop Counting Mode; START Counting; STOP Counting; Get Current Version Number

Lighthouse REMOTE-2 PN Series Operating Manual
4-8 248083310-1 Rev 3
<aa#> Set Alarm Channel #
<ab#> Set Alarm Threshold (# of counts)
<ae#> Set Alarm Suppression #
START/STOP COUNTING MODE
START Counting
<sa>
This will start the device’s counting mode. When implemented, the
unit will wait until the sample time passes before displaying the sample
data.
Type:
<sa>
Response:
<sa>START
Sample: ch1-2: 0, 0 Range1= 10000, Range2= 5000.
Sample: ch1-2: 0, 0 Range1= 10000, Range2= 5000.
STOP Counting
<sb>
This will stop the device’s counting mode.
Type:
<sb>
Response:
<sb>STOP
GET CURRENT VERSION NUMBER
<gv>
Shows current version number of the device firmware.
Type:
<gv>
Response: