Lighthouse REMOTE 2 Series - Installation

Lighthouse REMOTE 2012, 3012, 5012, 3102, 5102 Operating Manual
3-4 248083201-1 Rev 6
Figure 3-5 J10 Labeling (without Status feature on pin 5)
Installation Your instrument(s) can be easily prepared for use by performing the
steps below. Depending on the unit’s output, each instrument can be
located up to 1000 feet (330 meters) from the counting device.
1. Locate instrument(s) in areas to be sampled.
2. Attach barbed fitting to top inlet.
Figure 3-6 Attaching the Fitting
3. Attach sample tubing to barbed (top) fitting.
Figure 3-7 Attach sample tubing to inlet