Lighthouse REMOTE 2 Series - DIP Switch Settings; General Definitions; Time:range

Lighthouse REMOTE 2012, 3012, 5012, 3102, 5102 Operating Manual
4-2 248083201-1 Rev 6
Figure 4-2 Panel Removed, Switches Exposed
DIP Switch
Settings
GENERAL DEFINITIONS
OFF (DOWN) = 0, ON (UP) = 1
Switch Number1234 5678
Data 0000:0000
At Startup:
0000:0000==> Program Mode (ASCII terminal)
0000:0001==> Immediate Startup using last stored parameters
Anything Else==> DIP Switch Mode
Note: The DIP Switches
must be set before the unit
is powered ON.
Time:Range
When a DIP switch is set to any of the pre-programmed values listed
below and power applied to the instrument, information is echoed back
to the terminal, if connected.
These settings affect time and range only. All other parameters, such
as Alarm Value and Suppress Alarms, are left at their previous settings.
Time is the sampling time in seconds. The Range setting is applied to
both channels.
1 2 3 4 5 6 7 8
Switch
Numbers