00
248083201-1 Rev 6 5-1
5 Technical Data
Introduction This chapter describes the operation and programming of the
instrument.
Control
Design
Figure 5-1 States for the 3012, 5012, 3102, 5102 Particle Counter
START
• Starts microprocessor, and initializes hardware.
SETUP
• If DIP Switches all = 0 ==> Program Mode:
During the first 20 seconds, the unit waits for programming
commands. If any programming commands are received within the
first 20 seconds, those commands will be examined and executed.
If the commands are valid, the parameters will be set. If no
Start
Setup
Count Timer
Alarm
Output
Counts
To Next Page
Loading...
