Lighthouse REMOTE 2 Series - START Counting; Start;Stop Counting Mode; STOP Counting

Lighthouse REMOTE 2012, 3012, 5012, 3102, 5102 Operating Manual
4-10 248083201-1 Rev 6
Type:
<m1>
Response:
<m1>
*** User Menu ***
<?> Display Parameters
<V> Verbose Mode
<sa> Start Counting
<sb> Stop Counting
<gv> Get Version Number
<ra#> Set Range 1 (counts)
<rb#> Set Range 2 (counts)
<ta#> Set Sample Seconds
<aa#> Set Alarm Channel #
<ab#> Set Alarm Threshold (# of counts)
<ae#> Set Alarm Suppression #
START/STOP COUNTING MODE
START Counting
<sa>
This will start the device’s counting mode. When implemented, the
unit will wait until the sample time passes before displaying the sample
data.
Type:
<sa>
Response:
<sa>START
Sample: ch1-2: 0, 0 Range1= 10000, Range2= 5000.
Sample: ch1-2: 0, 0 Range1= 10000, Range2= 5000.
STOP Counting
<sb>
This will stop the device’s counting mode.