00
248083201-1 Rev 6 4-1
4 Programming
General The REMOTE 2 Series family of instruments can be programmed in
either of two ways. The DIP switches can be used to set the Sampling
Time and Range values. If an ASCII terminal is connected to the
instrument, it can program the unit’s Sample Time, Range, Service
High, Service Low, Alarm Threshold and Suppress Alarm Count.
This chapter contains the information needed to program the
instrument to meet your needs.
DIP Switches The DIP switches are behind a panel under the Data connector J10.
Figure 4-1 Panel Covering the DIP Switches
Remove the two Phillips head screws to expose the DIP switches.
To Next Page
Loading...
