Ethernet Installation
248083336-1 Rev 3 6-7
9. Activate the 3104P or 5104P Ethernet interface by typing, telnet
xx.xx.xx.xx 1 (replace x’s with the IP address to be used for the
3104P or 5104P) and press Enter. This command will cause a
connect error but is required to establish communications.
Figure 6-5 Telnet 1
10. Type telnet xx.xx.xx.xx 9999 and press Enter. This command
accesses the telnet port of the 3104P or 5104P. The expected
error message from Step 9. is shown in the example screen below.
Figure 6-6 Telnet 9999
You will have 4 seconds to respond in the next step. If you respond
too slowly, you’ll have to repeat step 10.
To Next Page
Loading...
