Lighthouse REMOTE 3104P, 5104P Operating Manual
6-8 248083336-1 Rev 3
11. Press Enter to start the 3104P or 5104P Ethernet interface setup
program. The example below displays some of the default
settings - make no changes to these settings except as instructed.
Figure 6-7 Starting the Set Up Program
12. Type 1 to set the IP address. Type the desired IP address and
press Enter.
Figure 6-8 Assigning IP Address
13. Type Y to set the Gateway IP address. Type the Gateway IP
address and press Enter.
To Next Page
Loading...
