Lightware SW4-OPT-TX240RAK

2.5. Rear view
HDMI-3D-OPT-TX210A
HDMI-3D-OPT-TX210RAK
SW4-OPT-TX240RAK
2.6. Rear view legend
1
SC ber output Connect a multi-mode single ber optical cable between the
transmitter unit and the receiver unit.
2
Audio2 in 5-pole Phoenix connector for asymmetric analog audio input signal.
Pin assignment can be found in section 2.7.3 on page 16.
3
HDMI out Local HDMI output with the same A/V content as the ber optical
output.
4
Status LEDs The LEDs give immediate feedback about actual state of the device.
For more information see the table on the next page.
5
RS-232 3-pole Phoenix connector for RS-232 serial port. Pin assignment
can be found in section 2.7.2 on page 16.
6
DC 5V in Local power in; connect the output of the supplied 5V DC power
adaptor. CAUTION! Warranty void if damage occurs due to use of
a different power source. For more information see section 2.7.1 on
page 15.
7
Ethernet Locking RJ45 connector. Remote control port for connecting the
extender to a Local Area Network (LAN) and to be controlled with
LDC.
8
GPIO 8-pole Phoenix connector for congurable general purpose input/
output ports. Pin assignment can be found in section 2.7.4 on page
16.
1 2 3
4 5 6
1 2 3 4 5 6
1 2 3 7 4 8
5 6
Page 14 / 106 Installation and controls