Linak CBD6S 200W

Page 12 of 24
Description of the DESKLINE
®
system
Each DESKLINE
®
actuator/column is equipped with a motor and parallel/memory drive is ensured by means of
software in the CBD6S that also takes account of an uneven load on the desk. Soft start and stop are also
part of this software, which ensures a soft start and stop when adjusting the desk.
Application of the DESKLINE
®
system:
Irrespective of the load the duty cycle max. 5% ~ 1 min./ 19 min., max. 1 min. at continuous use
followed by 19 min. pause stated in the data sheets, must NOT be exceeded as this will result in an
overheating of the motor and control box. Exceeding the duty cycle will result in a dramatic reduction of the
life of the system.
The system range contains the following products:
• 1 control box CBD6S 200W or CBD6S 300W (SMPS - Switch Mode Power Supply)
• 1, 2, 3 or 4 DL2 lifting columns
• 1 exchangeable mains cable
• motor cables (1 - 4 (4))
• 1 DP1U/DPF1M (if memory function is required) DP1C/DPT/DPF1C (if memory function and display is
required) or 1 DPA/DPB/DPH/DP1K/DP1V/DPF1K (if only up/down is required.)