Before installation, re-installation, or troubleshooting
•
Stop the DL2
•
Switch off the power supply and pull out the mains plug.
•
Relieve the DL2 of any loads, which may be released during the work.
Before start-up:
•
Make sure that the system has been installed as instructed in this User
Manual.
•
Make sure that the voltage of the control box is correct before the
system is connected to the mains.
•
System connection. The individual parts must be connected before the
control box is connected to the mains. See the User Manual for LINAK
actuators, if necessary.
During operation:
•
If the control box makes unusual noises or smells, switch off the mains
voltage immediately.
•
Take care that the cables are not damaged.
•
Unplug the mains cable on mobile equipment before it is moved.
•
The products must only be used in an environment, that corresponds
to their IP protection.
Misc.
The actuator system has a sound level below 55dB(A) in typical
applications.
Updated manuals and declarations can always be found here:
www.linak.com/deskline
To Next Page
Loading...
