Linhai M565Li - Page 68

M565Li OWNER’S/OPERATOR’S MANUAL
14. BATTERY
68
Battery Installation and Connections
To avoid the possibility of explosion, always connect battery cables in the
order specified. Red (positive) cable first; black (negative) cable last. An
exploding battery can cause serious injury or death.
Battery terminals and connections should be kept free of corrosion. If cleaning is
necessary, remove the corrosion with a stiff wire brush. Clean the terminals with
electric spray cleaner such as Maxima Electrical Contact/Brake Cleaner. Coat the
terminals with dielectric grease.
1.
Place the battery in its holder.
2.
First connect and tighten the red (positive) cable.
3.
Second connect and tighten the black (negative) cable.
4.
Reinstall battery cover and attach the hold down strap.
5.
Verify that cables are properly routed.
NOTE:

When your ATV is in storage for 1 month or more, the battery should be
removed, charged to proper level, and stored in a cool dry place.

Before reusing, take the battery to your dealer for testing and recharging.
Power plug leads may need to be bent down so that battery cover may be
installed.

When installing a new battery, make sure it is fully charged prior to it is
initial use. Using a new battery that has not been fully charged can damage the
battery resulting in a shorter life of the battery. It can also hinder vehicle
performance.
Your ATV is equipped with 18Ah maintenance-free (MF) Battery.
This may not be sufficient to provide power for optional equipment.
When installing optional equipment please upgrade your battery as
necessary. See your dealer for the correct battery.