M565Li OWNER’S/OPERATOR’S MANUAL
16. MAINTENCE
91
NOTE: If warning labels are damaged, contact your dealer for
replacement.Your ATV can be waxed with any non-abrasive automotive
paste wax. Avoid the use of harsh cleaners since they can scratch the
body finish.
Certain products, including insect repellents and chemicals, will damage
plastic surfaces. Care must be taken when using these products on
plastic surfaces.
Storage Tips
Do not start the engine during the storage period. This will disturb the
protective film created by fogging.
Cleaning - Clean the ATV thoroughly.
Oil Add and Filter Change - Warm the engine and change oil and filter.
Air Filter/Air Box – Inspect, clean, oil or replace air filter. Clean the air box and
drain the sediment tube.
Inspect All Fluid Levels - Inspect the following fluid levels and change if
necessary: transmission; brake fluid (change every 2 years or as required if
fluid looks dark or contaminated).
Fog the Engine - Spray light oil into the cylinder through the spark plug hole.
Check and Lubricate Cables/Grease - Inspect all cables and lubricate.
Battery Maintenance – Regularly charge the battery. Apply Dielectric Grease
to the terminal bolts and terminals.
Storage Area/Covers - Set tire pressure and safely support the ATV with the
tires 25-50 mm off the ground. Be sure the storage area is well ventilated. Cover
the machine with an ATV cover.
NOTE: Do not use plastic or coated ATV covers. They do not allow for enough
ventilation and may promote corrosion and rust.
To Next Page
Loading...
