16
Network | LAN Settings
Network > LAN Settings
LAN Setting:
Ø LAN IP Address / LAN IP Subnet Mask: The IP address and subnet mask used by CPE in LAN
u If users choose other tunnel mode, this IP means LAN side domain and Web GUI IP addres
s. (This IP will change IP prefix in “DHCP Server”, “Port Forwarding” and “Port Trigger”)
DHCP Server: CPE has a built-in DHCP server to manage the distribution of IP addresses. A device
connected to CPE through the Ethernet port or WiFi would obtain a dynamic IP address from CPE.
DHCP Starting IP Address: The starting IP address assigned by DHCP server.
DHCP Ending IP Address: The ending IP address assigned by DHCP server.
Notice that WiFi and Ethernet share the same DHCP server, the range of IP
addresses should not be narrow. Otherwise, clients cannot get LAN IP addresses.
DHCP Lease Time: The lifetime of the IP assigned by DHCP server.
Enable DNS Proxy: When the checkbox is ticked, clients set CPE as DNS server, but CPE will only act as
a “DNS relay”.
If users want to know DNS Servers obtained from ISP, It can be found in “Status >
Network Status > DNS Server”
DHCP Lease Reservation: Setup a mapping IP addresses with specified DHCP lease time.
DHCP Lease Status: This table records the mapping of MAC and IP addresses. Clients with the specific
MAC address in the table would get the corresponding IP address. An example is illustrated below.
Reset fields to the last saved values.
Commit the changes made and save to the CPE device, some services will
be reloaded.
To Next Page
Loading...
