32
Management | Diagnostics
Management > Diagnostics
Use system Diagnostics tools to set up parameters such as Diagnostics Type, Protocol Type, Ping Count,
Packet Size, Ping Timeout, and get the Diagnostic Result afterward.
Diagnostic Tool: Select Ping or Traceroute to check network connectivity.
Ø IP Address/Domain Name: Enter the destination to check the CPE connectivity by IP address or
Domain name, for both IPv4 and IPv6.
Ø Ping Count: Setup how many ping packets you want to test.
Ø Ping Packet Size: Setup the size of ping packet you want to test.
Ø WAN/APN Interface: Setup which WAN interface you want to test.
To Next Page
Loading...
