55
o
Auto Negotiation—Select to enable auto-negotiation on the LAG. Auto-
negotiation is a protocol between two link partners that enables a LAG to
advertise its transmission speed and flow control to its partner (the Flow
Control default is disabled). It is recommended to keep auto-negotiation
enabled on both sides of an aggregate link, or disabled on both sides, while
ensuring that link speeds are identical.
o
Port Speed—Configure the speed of the LAG. The port types determine the
available speeds. You can designate this field only when port auto-
negotiation is disabled.
o
Auto Advertisement—Select the capabilities to be advertised by the LAG.
-
Max Capability—All LAG speeds and both duplex modes are
available.
-
10 Full Duplex—The LAG advertises a 10 Mbps speed and the
mode is full duplex.
-
100 Full Duplex—The LAG advertises a 100 Mbps speed and the
mode is full duplex.
-
1000 Full Duplex—The LAG advertises a 1000 Mbps speed and
the mode is full duplex.
o
Flow Control—Set Flow Control to either Enable or Disable or Auto-
Negotiation.
o
Description—Enter the LAG name or a comment.
4.
Click Apply. LAG membership is saved to the Running Configuration file.
To Next Page
Loading...
