81
Interfaces
The Interface Settings page displays and enables configuration of VLAN-related parameters for
all interfaces.
To configure the interface settings:
1.
Click VLAN Management > Interface Settings.
2.
Select an interface type (Port or LAG), and click Search. Ports or LAGs and their VLAN
Membership are displayed.
3.
To configure a Port or LAG, select it and click Edit.
Note—To add a port or LAG to a VLAN, click Join VLAN. The Join VLAN page is displayed.
4.
Enter the values for the following fields:
•
Interface—Select a Port/LAG.
•
Interface VLAN Mode—Select the interface mode for the VLAN. The options are:
-
Access—The interface is an untagged member of a single VLAN. A port
configured in this mode is known as an access port.
-
Trunk—The interface is an untagged member of one VLAN at most, and is a
tagged member of zero or more VLANs. A port configured in this mode is
known as a trunk port.
-
General Port—The interface can support all functions as defined in the
IEEE 802.1q specification. The interface can be a tagged or untagged
member of one or more VLANs.
To Next Page
Loading...
