Linksys LGS308

87
To assign a MAC address to a VLAN Group:
1. Click Configuration > VLAN Management > MAC-Based Group.
2. Click Add.
3. Enter the values for the following fields:
•
Group ID—Enter a user-created VLAN group ID number.
•
MAC Address—Enter a MAC address to be assigned to a VLAN group.
Note—This MAC address cannot be assigned to any other VLAN group.
•
Prefix Mask—Enter one of the following:
-
Host—Source host of the MAC address
-
Length—Prefix of the MAC address
4. Click Apply. The MAC address is assigned to a VLAN group.
MAC-Based VLAN per interface
See Table 1 for a description of the availability of this feature. Ports/LAGs must be in General
mode.
To assign a MAC-based VLAN group to a VLAN on an interface:
1. Click Configuration > VLAN Management > MAC-Based VLAN.
2. Click Add.
3. Enter the values for the following fields:
•
Interface—Enter a general interface (port/LAG) through which traffic is received.
•
Group ID—Select a VLAN group, defined in the MAC-Based Groups page.
•
VLAN ID—Select the VLAN to which traffic from the VLAN group is forwarded.