Linksys VELOP MX5500 Series User Manual

31
How to restore factory defaults
You should never need to factory reset your Velop—a very disruptive process. A factory reset
restores your Velop system to the state it was when you took it out of its box, requiring you to go
through the setup process again. All settings you have customized in setup and since – things such as
Wi-Fi name, passwords, security type – will be erased. All wireless devices will disconnect from your
Wi-Fi.
To reset Velop:
•
With your node connected to power and turned on, press and hold the Reset button on the
bottom. The light on top of the node will turn red and fade in pulses. Do not release the button
until the light goes out and then turns bright red.

Linksys VELOP MX5500 Series Specifications

General

Processor	1.4 GHz Quad-core
Memory	512 MB RAM, 512 MB Flash
Security	WPA3, SPI Firewall
Mesh Technology	Yes
MU-MIMO	Yes
OFDMA	Yes
Beamforming	Yes
Guest Network	Yes
App Support	Linksys App
Wi-Fi Technology	Wi-Fi 6
Wi-Fi Bands	2.4 GHz, 5 GHz
Coverage	Up to 3000 sq ft per node
Number of Nodes	1-3
Ethernet Ports	2 Gigabit Ethernet ports per node
WAN Ports	1 Gigabit WAN port per node
Parental Controls	Yes (via Linksys app)
Power Supply	100-240V, 50-60Hz