Rev: 03.25.19 Page 6
CCD-0001447
Optional OneControl Voice features activation instructions are as follows:
1. If necessary, create an end user account with Amazon.com through Amazon's website.
2. Enable Amazon Alexa on the Amazon.com account.
3. Install an Alexa voice-device-compatible OneControl Voice system, i.e. Amazon Echo Dot.
4. Add the OneControl Voice skill to the Alexa account and give Alexa permission to access the
ConnectAnywhere system.
Pre-activation Check
Before operating the ConnectAnywhere system, perform the following pre-operation checks to ensure the
system will operate smoothly.
1. Locate the KCODE serial number (Fig. 2) printed on the OneControl Cloud Gateway label and make a
copy of it for later use.
NOTE: The KCODE uniquely identifies the ConnectAnywhere system on the Internet and is used during
product activation. Take care not to lose this number.
Fig. 2
The terminator resistors are required for proper operation of the CAN bus. They are already installed
in the system. Make sure these remain installed whenever modifying the OneControl system.
2. Make sure an Internet hotspot is installed and working properly prior to operating the
ConnectAnywhere system.
NOTE: An existing Internet connection
†
is required by the product.
3. Verify the unit is equipped with electronics compatible with the LCI OneControl system. To do this,
locate an LCI module and verify that a CAN (Controller Area Network) bus is installed on the unit.
If one or more LEDs are not showing proper indication, then something is wrong with the
installation. The problem MUST be remedied before the unit can be accessed remotely.
See the Troubleshooting section for additional information.
NOTE: Two CAN connectors are present on every OneControl electronic module. Both connections must
be populated for the system to operate.
4. Wait approximately one minute for the system to finish booting before checking LED status. Refer to
the following Cloud Gateway Status Chart.
To Next Page
Loading...
Need help?
General
