Rev: 10.13.21 Page 10 CCD-0004221
Learn A Sensor
A screen will appear on the display for five seconds (Fig. 3) before automatically transitioning to the
notifications received before sensor learning takes place.
1. Before accessing the SETTINGS menu, check to make sure the vehicle on which a sensor is to be
learned is present on the main tire pressure screen (Fig. 9).
2. Tap the arrow to the right of Learn A Sensor (Fig. 18A).
3. The vehicle will at first appear without a red blinking dot. Select the tire with a sensor to be learned
(Fig. 19A) and observe a red blinking dot on that tire (Fig. 20A).
NOTE: The procedure for learning a sensor is the same as relearning sensors.
4. Hold the LCD display close to the sidewall in the area opposite the valve stem of the tire to be
paired (Fig. 21).
5. Tap and hold the sync button on the LCD display to pair the sensor until the display beeps and the red
flashing circle turns green (Fig. 21).
6. The display will feature a red dot representing the tire that is being paired, which will then turn green
when it is successfully paired.
Fig. 18
Fig. 19
Fig. 20
Fig. 21
A
A
A
To Next Page
Loading...
Need help?
General
