Lippert Tri-Fold Sofa - Arm and Foot Assembly Replacement; Arm Insert Installation; Foot Assembly Installation; Care, Cleaning, and Maintenance

Rev: 05.22.23 Page 11 CCD-0001740
Arm Insert Replacement Instructions
1. The arm insert has a tack strip on the back. Remove the old arm insert by prying the insert off the arm.
2. Install the new arm insert by tapping on the front with a mallet (Fig. 16).
Fig. 16
Fig. 17
Care and Cleaning
Use warm water only to clean material. Lippert does not suggest any chemicals of any sort.
Maintenance
It is recommended that the bolts and nuts of the legs of the fold out portion of the Tri-Fold Sofa be tightened on a
monthly basis. Over time the bolts and nuts can loosen, which could cause damage to the middle cushion cover.
Arm Insert
Foot Assembly Replacement Instructions
1. Remove the old foot assembly by removing the two screws at the bottom of the foot assembly (Fig. 17).
2. Install the new foot assembly by inserting the two screws into the bottom of the new foot assembly
(Fig. 17).