Lippert Tri-Fold Sofa - Preparation and Component Replacement; Required Tools for Preparation; Back Cushion Assembly Replacement; Back Cushion Foam Replacement

Rev: 05.22.23 Page 5 CCD-0001740
Fig. 2
Preparation
Resources Required
NOTE: Resources required may vary due to actual operation performed. Listed below is what may be
required.
Hook and Loop
Fabric Strips
• Cordless or electric screw gun or drill
• ½" Socket (Import tri-fold sofas may use a
8mm socket)
• Appropriate screw drivers
• Appropriate drive bits
Back Cushion Replacement Instructions
Full Cushion Assembly
1. Remove cushion from sofa. The cushions are held in place by hook and loop fabric strips (Fig. 2).
2. Place new cushion back on sofa.
Cushion Foam
1. Remove back cushion from the sofa. The cushions are attached by hook and loop fabric strips (Fig. 2).
2. Unzip and remove cover from foam.
3. Discard the foam.
4. Insert new foam into cover.
5. Zip cover completely around new foam.
6. Place cushion back on sofa.
Cushion Cover
1. Remove the cushion from the sofa. The cushions are attached by hook and loop fabric strips (Fig. 2).
2. Unzip and remove the cover from foam.
3. Discard the cover.
4. Insert new cover around foam cushion.
5. Zip new cover completely around foam.
6. Place cushion back on sofa.