Lippert Tri-Fold Sofa - Attaching Kick Rails to Arm Rests; U-Bar and Seat Cushion Assembly

Rev: 05.22.23 Page 13 CCD-0001740
Assembly Instructions
NOTE: Be sure that the front kick rail is correctly oriented with the lettering facing the front (Fig. 19).
1. Lift the arm rests to an upright position and lift the rear kick rail end and slide bracket into the rear slot
bracket attached to the arm rest. (Fig. 20). Repeat the process on the opposite side.
2. Lift the front kick rail and align the slide bracket with the slot bracket on the front arm rest (Fig. 21).
Repeat the process on the opposite side.
Fig. 19
Fig. 20
NOTE: It is necessary to remove all screws that are assembled with the U-bar and seat cushion assembly.
There is six screws total, four in the back u-bar and two on each side (Fig. 22).
Fig. 21
Side screw
Back screws
Fig. 22