Lippert Tri-Fold Sofa - Stationary Back Component Replacement; Full Stationary Back Assembly; Stationary Back Interior Foam; Stationary Back Interior Frame

Rev: 05.22.23 Page 6 CCD-0001740
Stationary Back Replacement Instructions
Full Stationary Back Assembly
1. Remove back cushions from sofa and set aside.
2. Unfold front seat and middle seat to expose mounting bolts and nuts (Fig. 3).
3. Remove the two nuts and two bolts from each mounting bracket and set aside (Fig. 4). Discard back
assembly.
Fig. 4
Fig. 3
Stationary Back
V2 Frame
Mounting Bracket
4. Set new back assembly in place with holes in mounting brackets aligned with holes in V2 frame.
5. Insert bolts through mounting bracket and V2 frame.
6. Secure bolts with nuts.
7. Fold front seat and middle into stored position.
8. Reattach back cushions.
NOTE: To replace the stationary back interior foam, stationary back interior frame or stationary back cover,
the stationary back assembly needs to be removed first for easier access.
Stationary Back Interior Foam
1. Unzip cover from the stationary back.
2. Remove and discard foam.
3. Place new foam on the interior frame.
4. Slip cover over the interior frame and foam.
5. Zip cover completely.
Stationary Back Interior Frame
1. Unzip cover from the stationary back.
2. Remove and discard the old interior frame.
3. Place foam on the new interior frame.
4. Slip cover over the interior frame and foam.
5. Zip cover completely.
Stationary Back Cover
1. Unzip cover from the stationary back.
2. Remove and discard the old cover.
3. Slip new cover over the interior frame and foam.
4. Zip cover completely.