Lippert Tri-Fold Sofa - Couch Seat Component Replacement; Couch Seat Assembly Detachment; Couch Seat Foam Replacement

Rev: 05.22.23 Page 7 CCD-0001740
Fig. 5
Fig. 6
Cotter Pin
Clevis Pin
Steel Tab
Couch Seat Replacement Instructions
Couch Seat Assembly
1. Remove cotter pins from the end of the clevis pins (Fig. 5).
NOTE: There is one clevis pin on each side of the Tri-fold sofa at the bottom of the seat. The clevis pins are
attached to the steel tab connected to the middle seat.
2. Push clevis pin through hole (Fig. 6) of the steel tab with a screw driver.
3. Repeat on the other side. The couch seat will detach from the middle seat.
NOTE: The steel tab (Fig. 6) connects the couch seat to the middle seat. The shorter end of the steel tab
goes to the V2 frame. The longer end of the steel tab goes to the seat.
NOTE: To replace the couch seat interior foam, couch seat interior frame or couch seat cover, the couch
seat assembly needs to be removed first for easier access.
Couch Seat Interior Foam
1. Unzip cover from the couch seat (Fig. 7).
2. Remove and discard foam.
3. Place new foam on the interior frame.
4. Slip cover over the interior frame and foam.
5. Zip cover completely.
Fig. 7