Lippert Tri-Fold Sofa - Couch Seat Frame Replacement; Couch Seat Cover Replacement; Couch Seat Legs Replacement; Middle Seat Component Replacement

Rev: 05.22.23 Page 8 CCD-0001740
Fig. 8
Bolt
Nut
Fig. 9 Fig. 10 Fig. 11
Clevis Pin
V2 Frame
Cotter Pin
Couch Seat Interior Frame
1. Unzip cover from the couch seat.
2. Remove and discard the old interior frame.
3. Place foam on the new interior frame.
4. Slip cover over the interior frame and foam.
5. Zip cover completely.
Couch Seat Cover
1. Unzip cover from the couch seat.
2. Remove and discard the old cover.
3. Slip new cover over the interior frame and foam.
4. Zip cover completely.
Couch Seat Legs
1. Remove the legs by removing the (4) bolts and nuts (Fig. 8) on either side.
2. Place new legs in the same position the old legs were removed from and add bolts and nuts.
Middle Seat Replacement Instructions
Middle Seat Assembly
1. Remove one side of V2 Frame first. Start by removing three screws using a combo head square drive (Fig. 9).
2. Remove cotter pin (Fig. 10).
3. Lift up, push clevis pin out from the steel tab using a screw driver (Fig. 11).
4. Repeat 2-3 for the other side of the seat.
NOTE: During replacement, make sure the pillow side of the middle seat is up.
NOTE: To replace the middle seat interior foam, middle seat interior frame or middle seat cover the middle
seat assembly needs to be removed first for easier access.