LiteOn EVO 6800 Series - Page 85

82
Parameter
Name
Description
Setting Range
1
∶
Accept Active Run Command at the New
Source
If a run command at the new source is active,
the drive will accept it and run the motor
immediately right after switching from the old
source to the new source.
b1-06
Run Command
Selection during
Programming
0
∶
Run command disabled during
Programming
1
∶
Run command enabled during
Programming
2
∶
Prohibit programming during run
The programming mode cannot be
displayed during run except for monitoring
parameter Group U.
Default
∶
0
Min.: 0
Max.: 2
b1-07
<8>
Frequency
Command
Selection 2
Enabled while E1-00 to E1-07 is set to 4 and
the DIP switch is set to OFF
0
∶
Keypad
1
∶
Control Circuit Terminal (Analog Input)
2
∶
Terminal Up/Down
3
∶
Modbus Communication
4
∶
Pulse Train Input (Including PWM signal
input)
5
∶
Automatic operation
6: Expansion card
Default
∶
0
Min.: 0
Max.: 5
Remarks:
The maximum
number of models
above F3: 6
b1-08
Run Command
Selection 2
Enabled while E1-00 to E1-07 is set to 4 and
the DIP switch is set to OFF
0
∶
Keypad
1
∶
Control Circuit Terminal (Sequence
Control Input)
2
∶
Modbus Communication
3: Expansion card
Default
∶
0
Min.: 0
Max.: 2
Remarks:
The Max. value for F3
and above is 3
b1-09
Frequency
superposition
Selection
0: Disabled
1: Enabled
Default
∶
0
Min.: 0
Max.: 1
b1-10
Run Command
at Power up
Determines to accept or ignore an active Run
command from Remote during power up.
0
∶
Ignore
Drive ignores an active run command during
power up
1
∶
Accept
Default
∶
0
Min.: 0
Max.: 1