118
Zero servo moving
pulse number
Display position deviation
After the automatic adjustment of the PM magnetic
pole offset angle, observe this parameter to confirm
whether the Resolver and the motor are in the
same direction, which means the same and the
negative represents the opposite.
<1> The factory setting differs depending on the inverter capacity selection, control mode selection,
and ND/HD selection settings.
<2> Please refer to the user manual http://www.liteon-ia.com/CHT/download.php.
<3> The 440V model needs to be multiplied by 2.
<4> Parameters that can be set when the inverter is running.
<5> The parameter setting upper limit value is changed according to the settings of d1-02
(maximum output frequency), d1-13 (maximum output frequency of motor 2), and L2-00
(frequency command upper limit value).
<6> If you find an abnormal situation, please contact the original factory.
<7> This function software version V1.40 or above is open.
<8> When the input voltage is set to 400V or higher, the factory setting is 395V. When the input
voltage is set to 399V or less, the factory setting is 350V.
Due to the adjustment of some parameters, please refer to the manual information on the website
for the latest parameters.
http://www.liteon-ia.com/TW/download.php
To Next Page
Loading...