Lithion HOMEGRID Stack'd Series - Page 12

Page 12 Chapter 2: Introduction
Status code: The code will only be displayed if a fault occurs. If the system is operating
normally the code will not be shown. The alarm codes are shown in the table below：
Numerical
value
Alarm indication
Numerical
value
Alarm indication
000
Normal
014
Charging circuit fault
002
Low voltage protection
015
Cell failure
003
Charging over current
protection
016
NTC failure
004
Discharge over current
protection
019
External equipment communication fault
005
Short circuit protection
020
Internal equipment communication fault
006
Charging high temperature
022
Relay over temperature protection
007
High discharge temperature
023
Copper bus over temperature protection
008
Low charging temperature
025
Lost communication between screen and device
009
Low discharge temperature
051
Total pressure overcharge protection
011
High ambient temperature
052
Total pressure over discharge protection
012
Excessive differential
pressure
053
Low ambient temperature protection
013
Discharge circuit failure
054
MOS over temperature protection
NOTE:
●When the system is charged the display streamline gathers in the middle. When it is discharged the display
streamline disperses to both sides
Status code