Page 32 Chapter 7: Trouble Shooting Steps
(5) Turn on the power switch on the controller module. Observe that the display screen has
no alarm protection status, the number of battery modules has no loss and flicker, and the
system parameters and status display are normal. The display will indicate the number of
battery modules that the controller has found.
（6）Assemble the fixing brackets for the battery module accessories into a long strip and
mount them in the middle of the left-hand side of the system.
（7）After normal operation, the system protection side plate shall be installed on the battery
module and the main control device to prevent scratches and bumps inside the battery
Connect and fix the barbs at both ends of the battery module with the snap of the protective
side plate
（8）Install the protective side plate and fix the screws, the right side of the main control
board shall be 14~20mm away from the side of the main control box and put the side plate to
the right against the box until it is closed. Finally, completing the installation of the main
To Next Page
Loading...