21
3.5 Low Alarm
The “LOW ALARM” screen allows programming of the Low Conductivity
reading that activates an alarm LED and output relay.
Press “ENTER” from “LOW ALARM” screen to change this value. The
setting will have a ashing cursor indicating that the value can be changed.
Press the “UP” or “DOWN” key to increase or decrease the setting. Press
“ENTER” to save the value.
LO ALARM 250
Low Conductivity Alarm Set Point
CONDUCTIVITY
SET POINT
LOW ALARM
HIGH ALARM
FEED
MANUAL OUTPUT
ADVANCED SETUP
TEMPERATURE
H
2
O METER
∆ DIFFERENTIAL
BOILER
LO ALARM 250
(866) 433-6682 • (281) 359-8538 • sales@novatech-usa.com • www.novatech-usa.com
To Next Page
Loading...
Need help?
General
