To Next PageTo Next Page
Need help?Do you have a question about the LNS QUICK LOAD SERVO S3 and is the answer not in the manual?
Overview of the bar feed system's function and purpose.
Setting the point for detecting the end of the bar stock.
Configuring the position for bar cutting or machining.
Steps for setting up the system for round bar stock.
Steps for setting up the system for hexagonal bar stock.
Steps for setting up the system for square bar stock.
Steps for setting up the system for special profile bars.
Procedures for replacing and adjusting the feeding pusher.
Setting the mechanical safety stop for the pusher.
Adapting the system for loading tubing stock.
Adjusting the loading table's vertical position.
Modifying the table slope for optimal bar sliding.
Adjusting loading fingers for correct bar handling.
Using reduction tubes for improved bar guiding.
Specific setup for hex and square bars with lathes.
General
