To Next Page

To Previous Page

FIGURE 12.20 SETTING MAINTENANCE ALERTS (ctd.)

NOTE: This maintenance reminder function is disabled by default; it is a programmable function to be used as a

notification that maintenance is required. Because the parameters are freely programmable, the

function cannot be used as a reason to not carry out the required routine maintenance or as an

argument in warranty cases.

The boiler must be maintained in accordance with Section 16.0: MAINTENANCE irrespective the settings/working

of this function.

Screen: Message after total amount of burning hours.

M a i n t e n M o d e

B u r n i n g h o u r s

Press [►] to set:

The total amount of burning hours for the Maintenance message.

Press [◄] to:

Return to maintenance mode selection.

The flashing value can be changed with [▲] & [▼]

Confirmation screen:

A r e y o u s u r e

< C a n c e l ; > C o n f i r m

Press [◄] to cancel the changes or [►] to confirm the

Screen: No maintenance message will be displayed.

M a i n t e n M o d e

M a i n t e n O f f

Confirmation screen:

A r e y o u s u r e

< C a n c e l ; > C o n f i r m

Press [◄] to cancel the changes or [►] to confirm the

Note: The [MENU] button will return the display to the operating screen.

changes. After the boiler returns to operating screen.

Press [ENTER] to confirm the changes.

changes. After the boiler returns to operating screen.

Press [ENTER] to confirm the changes.

> > > From previous page < < <

Lochinvar CP-M Series User Manual

Questions and Answers: