Loctite 97105 - Connection of the Equipment

Installation4
30
● Insert this empty bottle into the reservoir to check the adjustment of the sensor.
● For 250 ml product bottle, pay attention to the correct position with respect to the level sensor.
● On the reservoir, remove the cap from the level
sensor.
● With an electrician’s screwdriver, find the point
at which the sensor switches to the condition
inactive. The yellow LED extinguishes.
☞
The correct adjustment is exactly the point when the sensor switches off.
Do not go beyond that point!
The adjustment is correct, if the lower of the two green LED’s are burning when a full bottle is
inserted.
● Check this adjustment with a full bottle and the empty bottle again, if it is correct.
● Remove the empty product bottle.
● Close the housing. Insert and tighten the screws.
4.4 Anschließen der Geräte
Anschließen des Produkttanks 97105 bzw. 97107
Loctite (Ireland) Ltd.
Made in Germany
cat.no.97101
90–260 VAC/47–63 Hz
2 AM
XS1
XS1: Start
XS2: Reservoir
Loctite (Ireland) Ltd.
Made in Germany
cat.no.97102
XS2
XS2/IN: Controller
XS2/OUT:Tank B
max. operating pressure
8 bar
operating temperature.
0 to +50C
volume:
3,5 Liter
Loctite (Ireland) Ltd.
Made in Germany
XS2/IN
XS2/OUT
P in
97105
97107
97102 97101
P in