Loctite 97105 - Page 36

36
Type of malfunction Possible causes Correction
No product. – Product reservoir is empty.
The red LED on the automatic reservoir
is lit.
– Product reservoir is not switched on.
– Reservoir (product reservoir) is not active.
– Product reservoir defect.
● Refill the product reservoir
(Section 5.2)
On the automatic reservoir, one of the
seven yellow LED´s was previously lit.
The lower the lit LED, the lower the filled
level.
● Set the depressurizing valve to
(pressurize).
● Controller 97102: Press button .
Controller 97103: Press button or
.
● Loctite Service.
B
A
Troubleshooting7
Replacing the Rupture Disc
☞
When the maximum allowable air supply pressure is exceeded, the reservoir is depressurized by the
bursting of the rupture disc. he punctured rupture disc must be replaces.
● Loosen the cover screw fasteners 2 and remove
the cover 1.
● Remove the screws and open the housing.
● Remove the rupture disc screw.
● Replace the punctured rupture disc with a new
one.
Replace and tighten the rupture disc screw.
Tightening torque: maximum 20 Nm
Affix the sypplied type plate.
● Close the housing. Insert and tighten the screws.
XS2/IN: Controller
XS2/OUT:Tank B
max. operating pressure
8 bar
operating temperature.
0 to +50C
volume:
3,5 Liter
Loctite (Ireland) Ltd.
M
a
d
e
in
G
e
r
m
a
n
y
X
S
2
/IN
X
S
2
/O
U
T
P in
20 Nm