Loepfe WeftMaster CUT-iT - Page 17

Operation
WeftMaster CUT-iT
www.loepfe.com 17
ð Display: «Address: X #Slaves: X» (Master/Slave address) when using just one unit: Address
(Master) = 0 and number of Slaves = 0
ð or
ð Display: «Address: X #Slaves: X» (Master/Slave addresses) when using Master and Slave: Address
(Master) = 0 and number of Slaves e.g. 2 depending on number of Slaves used)
ð or
ð Display: «Address: X» (Slave address) when using the control unit as Slave: Address (Slave) = e.g.
2
ð Display: «Wiretype»
ð Display: «Standby»
ð Device ready for operation.