Loepfe WeftMaster CUT-iT - Setting the current strength

Operation
WeftMaster CUT-iT
www.loepfe.com 21
4.3.7 Setting the current strength
Activating when changing settings interrupts the process and Setting mode is
exited without saving the changes.
Standby current strength with machine stopped
ü The weaving machine is idle.
1.
Press for 3 seconds.
ð Display: «Tune-Standby» (setting in Standby mode)
2. Press to select desired setting.
3. If no button is pressed within 10 seconds.
ð Setting mode is exited without saving any changes.
4.
Press to confirm desired setting.
ð Display: «Execute» (execute)
ð The setting is saved.
Run current strength with machine stopped
ü The weaving machine is idle.
1.
Press for 3 seconds.
ð Display: «Tune-Standby» (setting in Standby mode)
2. Press to switch to settings in« Run mode» .
ð Display: «Tune-Run Current» (current strengths setting in Run mode)